Ze Ubersaw

<insufferable nerd>

Tiny ubersaw! Made out of boredom between actual projects. Nickle, silver, steel, brass, and anodized aluminum. Last shot is just a close up of the sliding catch I built for it, cause I'm pimp like that. (it is a badge)

</insufferable nerd>

That's really cool, good job

What if you just replaced all of your silverware with Ubersaws?

Dude, nice. What's the crit rate on that thing?

Dingo you are AMAZING.

How tiny is it?  There's nothing to compare it to relatively....

Sharpen it up and paint blood splatter on the sides. Awesome stuff right there dingo, gw.

Quote:

With all your stuff you should put a ruler in the pic or something, I had this same question and it isn't the first time I've wondered about the size (belt buckles come to mind). Very nice as always.

From the context of the table I'd guess about 9-15 inches but its hard to tell

lool, no, teeny. It's a badge, remember. About 10 cm X 3.5 cm. That's my bench pin it's sitting on. I'll try to remember to include a size referance on anything else I post.

I would sharpen it but a) It's meant to be worn and b) Nickle doesn't hold an edge for shit. I WAS going to use aluminum (which also doesn't hold an edge for shit) and anodize the splatters on but that in itself would've come with a whole clown car of technical workarounds. So nickle it is. I may go back and do a second version out of aluminum. We'll see how I feel after my grad piecies are done. :/

Quote:

That's no dude, dude. That's a dudette.

That is freaking incredible.

Dingo, you continue to astound.

Should host a Medic battle tourney--first prize gets the badge.